simplify 3d different settings for different regions of a model

Allow gap fill when necessary: This setting will work to add in another perimeter by allowing as long as it's within the overlap setting.

If there's room to fit multiple perimeters, it will print in multiple perimeters, but otherwise you'd be left with a small gap.

Thin Wall Behavior Only use perimeters for thin walls: If printing a very thin wall, this means that the software will not add in Infill into a very small crevices. Using Merge all outlines is generally really useful for models that have errors in the mesh or if using Vase Mode. For instance, if you had a model that was a block with screw-holes in it, but had 'Merge all outlines into a single solid model' on, the holes would not show up. Merge all outlines into a single solid model: This feature in the software will slice the model taking all of the outer most perimeter outlines and slice with those assuming a solid model as the interior. I personally have not needed to use the Discard option. These are relatively common, the best behavior traditionally is to use Heal to attempt to patch up these missing areas. Tutorial on printing different settings for different regions Slicing Behavior Non-manifold segments: Non-Manifold segments are errors in the mesh. Two Process Statue of Liberty Example: The first process would stop at 50 mm (assuming 50 mm is where the base ends) and the second process would have a starting point of 50 mm so that the second process print settings would be applied to everything after 50 mm. For instance, if printing the Statue of Liberty below, you may want to print the base of the statue at a much thicker layer height then the statue itself. Layer Modifications Section Start Printing at Height: All models in this process will start printing at _ Height (mm) Stop Printing at Height: All models in this process will stop printing at _ Height (mm) These two options are used primarily if you want to print with different settings in one part.

Simplify 3d different settings for different regions of a model